You may see the instructions at wikiHow, Inc. is the copyright holder of this image under U.S. and international copyright laws. Most clocks use three weights. the cables and pulleys can cause the cables to overlap and bind the movement. If . B) A long cardboard box containing the pendulum My clock is a Howard Miller. Ensure clock is positioned square. Some pendulums have a colored protective plastic film covering the pendulum disk. Wall Clocks- All counterclockwise (backwards) as described in Step 5: Setting Time. adjustment nut to the left.Note: One complete turn equals approximately ***These instructions were written for grandfather clocks built since about 1980. To correct this situation, rotate the minute hand backward 3-1/2 hours as described in STEP 5 of the set up operation, set the moon dial, and then set the time as described in STEP 6. The chimes chime at 5 after, 20 after, 35 after and 50 after the hour. Moving the hands in either the clockwise or counterclockwise direction while the automatic chime sequencing is in operation could damage the chime mechanism.CAUTION ON MOVEMENTS WITH DAY/NIGHT SHUT-OFF FEATURES: The Day/Night lever must be in the strike position (all the way up) when moving the hands. Feed the screw through the hole in the back of the case and also the piece of wood you are using and then line up the screw with the hole you have prepared in the wall . The rear access panel is held in place with plastic clips. Hang each weight on the pulley in the proper position as shown. If not, make another slight adjustment. Most grandfather clocks have a provision for changing the minute hand position to the dial so it can achieve this.